Hey I have owned a code for about a year now, and although I am very pleased with the design, I have been having some difficulties with the hardware. I just updated to the new firmware, and I am very happy to have control over the speed of the encoders, but I am still having some issues that I was hoping would be resolved with the update.
The issue I am having is somewhat random, and only happens with certain encoders. Some of the knobs, when twisted seem to stick, and continued twisting only causes fluctuation, up and down, of midi values. This is seriously impairing creatively speaking, and is a rather large headache. Is anyone else having these problems? Is this simply an issue of improper software setup? I have tried, as I said earlier, updating the firmware, and restoring the code to factory settings, but to no avail. Any input would be wonderful