Ok some one please help me!
Here is my situation....
I want to to send sysex messages to a hardware synth (i.e. korg dw 8000 ,ensoniq esq-1,SCI Six Trak, Kawai K3) to adjust the parameters
Now the question is where do i enter the sysex messages that are in the back of the synth manuals into the Brain and how do i assign them CC values (pots, encoders,and buttons,) from the Brain into the sysex message?
Below Is an example from the Korg DW 8000 manual using the cutoff parameter.
F0 42 30 03 41 15 00 3f F7 <------- how to plug the slider or knob cc value into the middle of a SysEx message?
|42||Manufacturer ID: 42 = Korg|
|3n||Where n = the MIDI channel of your DW-8000: 30 = channel 1...3f = channel 16|
|03||Device ID: 03 = DW-8000|
|41||Message: 41 = parameter change|
|15||Parameter offset: 15 = VCF cutoff|
|mm||Parameter value: 00 to 3f, which would be the value from the slider scaled to 0-63|
Please forgive me for my ignorance, but please be as constructive as possible.