I'm a new code user and have an older v1 code (I think it's fatter?).
It works fine with v222 firmware and editor 2.09, but I really need it to be able to send different channels on each control within a bank.
So I searched and found in the firmware download page and I found this :
The 100 Series of the Code firmware allows individual channel output for each Control. It is provided for legacy support.
Code v105 (Multi-Channel) (for encoders with silver shafts)
I downloaded this and updated the firmware to v105, but the code is no longer recognised by the 2.09 or 1.273 editors and only lights up one blue LED on the first encoder turned after it has been reset.
I have changed the firmware back to v222 and everything works fine except I really need to be able to send different channels for each control!
Does anyone have any advice or are there more old firmware versions available that I should try?
Also, for some reason, with my encoders in relative mode, when turned clockwise (inc) the cc value sent is 01, and when turned anticlockwise (dec) the cc value sent is 7E (126) which seems backwards to me.
Thanks in advance!