I have 2 encoders and 12 buttons connected. PCB 1 = 1L 1C PCB 2 = 2L 2C PCB 3 = 1 R PCB 4 = 2 R
and if i set it booth to enc -/+ i always got the second one reset to cc !!! What can i do? should i use a different row for the second one? any workarounds?
Comments
Are you using a brain jr or something else?
What do you mean by PCB 1-4?
yes, brain jr. and i have connected like in ...
http://wiki.lividinstruments.com/images/thumb/9/94/BrainJrEncoders.jpg/500px-BrainJrEncoders.jpg
... 1 and 2 like in the pic. the others are buttons
Is your firmware up to date?
yes 213_bl
And ... Brain_v2_JR_Configure_Installer_104
Ok does it work when you connect one at a time?
Can you take a picture of your setup to show how the encoder or encoders are connected?
Can you take a screen shot in the configuration software?
no, the second one always reset. i don`t have a cam. sorry. but i think its a config thing.
That's what i get when i config 1+2 as enc -/+....
http://postimg.org/image/i3zm78rgp/
When i try to config only the second as enc -/+ i get....
http://postimg.org/image/hgv5v7fd1/
I'm emailing you a .lmd preset file. In the editor you can select "open file" and navigate to this file. It should load up and enable two encoders in relative mode.
Its pretty straight forward. You just click the top two boxes to say "yes" to enc? and the top two boxes to say +/-. The next two rows of boxes will change themselves.
Either way the file should work for you!
when i load my screen looks ....
http://postimg.org/image/75bggk4n9/
than i send config + save
but when get settings...
http://postimg.org/image/xsrh3nmnf/
and when i tick enc mode by myself, save and so on... ..i get these settings:
http://postimg.org/image/fx9eg9okv/
strange?!?
i have found out that when i set this config :
http://postimg.org/image/4e1dhfkw5/
i get this and it works,
http://postimg.org/image/x9u6htq1f/
but when i disable enc on 5, 2 gets resets like before.
also when i leave it like on this
http://postimg.org/image/x9u6htq1f/
and than set button on 5 to toggle, ...
http://postimg.org/image/86umdjec7/
...???? and why 14 is set to +/-
i have manged it, i reset to defaults and set this: http://postimg.org/image/7vcc92u1h/ send+save and i get:
http://postimg.org/image/tzfgssvtf/ it works but isn't normal, or?