right now my 2nd code broke
the problem that i had with my the first machine just came again:
the code stopped receiving any signals in inactive banks.
if a value changes in bank 1, and i am currently in bank 2 -
the information displayed from the ledring when i go back to bank 1 is wrong.
and when i turn the nob, the value jumps.
when i load a liveset
only the active bank receives all the information -
when i go to the next bank - all the leds are blank.
the last time this happend i let the machine ship to a service department in germany -
and they could not find ore solve the problem for 6 (!!!) month
the shop just gave me the money back.
i bought one inbetween, because i had to keep up my work -
and the same thing happend now again.
everything works fine usually until after a few months i make changes to a lot of things in the editor and press save.
than the trouble starts.
so far i can say this:
- the editor is scrambling the on-board memory up
- ore the on-board memory from a whole batch is trash, and i am a very lucky guy
"Inactive banks can also receive messages at any time, and the changes are recorded to the Code's on-board memory. "
this is the firmware update log
- i use mac x 10.8.5
- i changed laptops and software so this is not the problem
- i updated firmware and editor
- i tried online editor
i know there is probably nothing you can do to help me, anything is welcome though.
but please dont tell me again that the problem is not clear
i will spend the next hours thinking if i should get a 3rd code ore not