Hello everyone,
I'm new with LIVID and MIDI code. Please,help me.
My module list : 1st row = 4E4F4B > 16K > 16B(1) > 4E4F4B
2rd row = 4F4B > 16B(2) > 16K 8F
The problem are
1.My 16B(1) module notes are triggering uncontrollably in default setting.
When I made some adjustment on 16B MIDI Setting some buttons has stopped working.
2.16B(2) seems to replicated the setting from 16B(1).
*Other modules are working fine. (I think)
NOTE : BrainV2 firmware updated to v178
Run on OSX 10.7.5

Thank you in advance!
Comments
What other modules do you have in your setup? Can you post a screeenshot of your alchemist setup?
Hi Jay,
Can you try swapping ribbon cables with the bad one? Perhaps the cable is kinked/bad?
I tried to swap ribbon cables around but it still doesn't work.
I sent you a detailed solution through the support center.
For anyone else having this problem, use the "advanced" section to disable the analogs that are streaming. In this case those analogs are not being used so it will not effect the device.
Thanks, Mark!